The ZD420 Series printer detect automatically media type (gap, notch or black mark) and dimensions using special sensors
We will explain you how to calibrate ZD420 Printers
SmartCal Procedure
-
Make sure that the media and ribbon cartridge (if printing in thermal transfer mode) are properly loaded in the printer and that the top cover of the printer is closed.
-
Press the POWER button to turn on the printer
-
When the printer is ready (fixed Statoverde lamp), press and hold the PAUSE and CANCEL buttons for two (2) seconds, then release them. Refer to the following image:
After the initial calibration for a specific media has been completed, no additional calibration will be required each time the media is replaced. The printer automatically measures the media to adjust small variations in media features during printing. By pressing Feed (Feed) one or two times after a new roll of media (same lot) is was installed, the labels will be synchronized. So the printer is ready to continue to print
Print Test with Configuration Report Including Machine and Network Configurations
-
Make sure that the media and ribbon cartridge (if printing in thermal transfer mode) are properly loaded in the printer and that the top cover of the printer is closed.
-
Press the POWER button to turn on the printer
Print Test with Configuration Report Including Machine and Network Configurations
Snap Hardware
Ita
Eng
